tve200_drm.h 4.5 KB

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104105106107108109110111112113114115116117118119120121122123124125126127128
  1. /* SPDX-License-Identifier: GPL-2.0-only */
  2. /*
  3. * Copyright (C) 2017 Linus Walleij <linus.walleij@linaro.org>
  4. * Parts of this file were based on sources as follows:
  5. *
  6. * Copyright (C) 2006-2008 Intel Corporation
  7. * Copyright (C) 2007 Amos Lee <amos_lee@storlinksemi.com>
  8. * Copyright (C) 2007 Dave Airlie <airlied@linux.ie>
  9. * Copyright (C) 2011 Texas Instruments
  10. * Copyright (C) 2017 Eric Anholt
  11. */
  12. #ifndef _TVE200_DRM_H_
  13. #define _TVE200_DRM_H_
  14. #include <linux/irqreturn.h>
  15. #include <drm/drm_simple_kms_helper.h>
  16. struct clk;
  17. struct drm_bridge;
  18. struct drm_connector;
  19. struct drm_device;
  20. struct drm_file;
  21. struct drm_mode_create_dumb;
  22. struct drm_panel;
  23. /* Bits 2-31 are valid physical base addresses */
  24. #define TVE200_Y_FRAME_BASE_ADDR 0x00
  25. #define TVE200_U_FRAME_BASE_ADDR 0x04
  26. #define TVE200_V_FRAME_BASE_ADDR 0x08
  27. #define TVE200_INT_EN 0x0C
  28. #define TVE200_INT_CLR 0x10
  29. #define TVE200_INT_STAT 0x14
  30. #define TVE200_INT_BUS_ERR BIT(7)
  31. #define TVE200_INT_V_STATUS BIT(6) /* vertical blank */
  32. #define TVE200_INT_V_NEXT_FRAME BIT(5)
  33. #define TVE200_INT_U_NEXT_FRAME BIT(4)
  34. #define TVE200_INT_Y_NEXT_FRAME BIT(3)
  35. #define TVE200_INT_V_FIFO_UNDERRUN BIT(2)
  36. #define TVE200_INT_U_FIFO_UNDERRUN BIT(1)
  37. #define TVE200_INT_Y_FIFO_UNDERRUN BIT(0)
  38. #define TVE200_FIFO_UNDERRUNS (TVE200_INT_V_FIFO_UNDERRUN | \
  39. TVE200_INT_U_FIFO_UNDERRUN | \
  40. TVE200_INT_Y_FIFO_UNDERRUN)
  41. #define TVE200_CTRL 0x18
  42. #define TVE200_CTRL_YUV420 BIT(31)
  43. #define TVE200_CTRL_CSMODE BIT(30)
  44. #define TVE200_CTRL_NONINTERLACE BIT(28) /* 0 = non-interlace CCIR656 */
  45. #define TVE200_CTRL_TVCLKP BIT(27) /* Inverted clock phase */
  46. /* Bits 24..26 define the burst size after arbitration on the bus */
  47. #define TVE200_CTRL_BURST_4_WORDS (0 << 24)
  48. #define TVE200_CTRL_BURST_8_WORDS (1 << 24)
  49. #define TVE200_CTRL_BURST_16_WORDS (2 << 24)
  50. #define TVE200_CTRL_BURST_32_WORDS (3 << 24)
  51. #define TVE200_CTRL_BURST_64_WORDS (4 << 24)
  52. #define TVE200_CTRL_BURST_128_WORDS (5 << 24)
  53. #define TVE200_CTRL_BURST_256_WORDS (6 << 24)
  54. #define TVE200_CTRL_BURST_0_WORDS (7 << 24) /* ? */
  55. /*
  56. * Bits 16..23 is the retry count*16 before issueing a new AHB transfer
  57. * on the AHB bus.
  58. */
  59. #define TVE200_CTRL_RETRYCNT_MASK GENMASK(23, 16)
  60. #define TVE200_CTRL_RETRYCNT_16 (1 << 16)
  61. #define TVE200_CTRL_BBBP BIT(15) /* 0 = little-endian */
  62. /* Bits 12..14 define the YCbCr ordering */
  63. #define TVE200_CTRL_YCBCRODR_CB0Y0CR0Y1 (0 << 12)
  64. #define TVE200_CTRL_YCBCRODR_Y0CB0Y1CR0 (1 << 12)
  65. #define TVE200_CTRL_YCBCRODR_CR0Y0CB0Y1 (2 << 12)
  66. #define TVE200_CTRL_YCBCRODR_Y1CB0Y0CR0 (3 << 12)
  67. #define TVE200_CTRL_YCBCRODR_CR0Y1CB0Y0 (4 << 12)
  68. #define TVE200_CTRL_YCBCRODR_Y1CR0Y0CB0 (5 << 12)
  69. #define TVE200_CTRL_YCBCRODR_CB0Y1CR0Y0 (6 << 12)
  70. #define TVE200_CTRL_YCBCRODR_Y0CR0Y1CB0 (7 << 12)
  71. /* Bits 10..11 define the input resolution (framebuffer size) */
  72. #define TVE200_CTRL_IPRESOL_CIF (0 << 10)
  73. #define TVE200_CTRL_IPRESOL_VGA (1 << 10)
  74. #define TVE200_CTRL_IPRESOL_D1 (2 << 10)
  75. #define TVE200_CTRL_NTSC BIT(9) /* 0 = PAL, 1 = NTSC */
  76. #define TVE200_CTRL_INTERLACE BIT(8) /* 1 = interlace, only for D1 */
  77. #define TVE200_IPDMOD_RGB555 (0 << 6) /* TVE200_CTRL_YUV420 = 0 */
  78. #define TVE200_IPDMOD_RGB565 (1 << 6)
  79. #define TVE200_IPDMOD_RGB888 (2 << 6)
  80. #define TVE200_IPDMOD_YUV420 (2 << 6) /* TVE200_CTRL_YUV420 = 1 */
  81. #define TVE200_IPDMOD_YUV422 (3 << 6)
  82. /* Bits 4 & 5 define when to fire the vblank IRQ */
  83. #define TVE200_VSTSTYPE_VSYNC (0 << 4) /* start of vsync */
  84. #define TVE200_VSTSTYPE_VBP (1 << 4) /* start of v back porch */
  85. #define TVE200_VSTSTYPE_VAI (2 << 4) /* start of v active image */
  86. #define TVE200_VSTSTYPE_VFP (3 << 4) /* start of v front porch */
  87. #define TVE200_VSTSTYPE_BITS (BIT(4) | BIT(5))
  88. #define TVE200_BGR BIT(1) /* 0 = RGB, 1 = BGR */
  89. #define TVE200_TVEEN BIT(0) /* Enable TVE block */
  90. #define TVE200_CTRL_2 0x1c
  91. #define TVE200_CTRL_3 0x20
  92. #define TVE200_CTRL_4 0x24
  93. #define TVE200_CTRL_4_RESET BIT(0) /* triggers reset of TVE200 */
  94. struct tve200_drm_dev_private {
  95. struct drm_device *drm;
  96. struct drm_connector *connector;
  97. struct drm_panel *panel;
  98. struct drm_bridge *bridge;
  99. struct drm_simple_display_pipe pipe;
  100. void *regs;
  101. struct clk *pclk;
  102. struct clk *clk;
  103. };
  104. #define to_tve200_connector(x) \
  105. container_of(x, struct tve200_drm_connector, connector)
  106. int tve200_display_init(struct drm_device *dev);
  107. irqreturn_t tve200_irq(int irq, void *data);
  108. int tve200_connector_init(struct drm_device *dev);
  109. int tve200_encoder_init(struct drm_device *dev);
  110. int tve200_dumb_create(struct drm_file *file_priv,
  111. struct drm_device *dev,
  112. struct drm_mode_create_dumb *args);
  113. #endif /* _TVE200_DRM_H_ */